I keep my computer and the GR-55 on 24/7, but the GR-55 times out for some reason. When I return in the morning, the GR-55 is off. At that point, GR FloorBoard (GFB) appears to be in sync with the GR-55, but in fact it is not. Selecting a patch in GFB does not change the active patch in the GR-55, and vice versa.
I cannot find a way to tell GFB "re-load everything from the GR-55". The only way I can figure out to recover from this situation is to terminate GFB and re-start GFB.
Is there a better way to do this?
Jon
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I keep my computer and the GR-55 on 24/7, but the GR-55 times out for some reason. When I return in the morning, the GR-55 is off. At that point, GR FloorBoard (GFB) appears to be in sync with the GR-55, but in fact it is not. Selecting a patch in GFB does not change the active patch in the GR-55, and vice versa.
I cannot find a way to tell GFB "re-load everything from the GR-55". The only way I can figure out to recover from this situation is to terminate GFB and re-start GFB.
Is there a better way to do this?
Jon