For the moment I work on a bread board.
And I have an issu with the DHT11.
It wired on pin 4.
I have an Oled screen too (oled work)
But I have a DHTxx error (some times I have temperature and humidity, not often)
I try with the TestDHT.ino (changing DHT22 to 11)
It doesn't work.
I also try with an another lib with a test code. And this time I have humidity and temperature.
My wiring seems good.
Have you a way to give message ? Because I'm stuck.
Best regards
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I try to build a DCP3
For the moment I work on a bread board.
And I have an issu with the DHT11.
It wired on pin 4.
I have an Oled screen too (oled work)
But I have a DHTxx error (some times I have temperature and humidity, not often)
I try with the TestDHT.ino (changing DHT22 to 11)
It doesn't work.
I also try with an another lib with a test code. And this time I have humidity and temperature.
My wiring seems good.
Have you a way to give message ? Because I'm stuck.
Best regards